The Shrimp Saver mesh liner fits any standard 5-gallon bucket and gives your live shrimp something to hold onto — reducing stress, cutting die-off, and keeping your bait working when it counts most.
Every design decision in the Shrimp Saver solves a specific reason live shrimp die in a bucket. Not marketing. Biology.
Shrimp instinctively climb. Dead-flat bucket walls give them nowhere to go — they pile up, stress out, and die. The Shrimp Saver mesh gives them a vertical surface to grip, spreading the load and cutting overcrowding at the bottom.
Stressed bait tanks the water fast. By reducing crowding and injury, the Shrimp Saver slows the water quality decline — so your shrimp stay oxygenated and active hours longer than a bare bucket.
Marine-grade mesh that doesn’t rust, corrode, or soften in saltwater. The wire base anchors flat to the bucket bottom. Install in 3 seconds. Pull it out and rinse. Done.
No instructions booklet needed. No special tools. If you can stretch something over a bucket, and use suction cups, you’re done.
Pull the Shrimp Saver out of the package. The mesh is flexible and rolls out flat in seconds.
Insert the net into your 5-gallon bucket, anchor it near the bottom with the 4 suction cups (wet first for better suction) and spread it around the bucket. It sits firm and won’t shift.
Pull the top lip of the mesh up and stretch it around the bucket rim. Tension holds it in place — no clips, no velcro but using the included rubber band or your bucket lid makes sure it stays put.
Real footage. Real shrimp. Real results on the water.
The Shrimp Saver is heading to shelves and online. Get notified the moment it drops — early buyers get an exclusive launch discount.
The Shrimp Saver is designed for any standard 5-gallon bucket — the kind you’ll find at hardware stores, bait shops, or already on your boat. If your bucket holds 5 gallons, the Shrimp Saver fits it.
Unpack it, insert the metal base into the bucket and spread it flat on the bottom, then stretch the top of the mesh around the bucket rim. Three steps, three seconds. No tools, no hardware.
Yes — it’s specifically built for saltwater environments. The mesh and all parts (suction cups and clips) are marine-grade materials that resist corrosion and don’t soften, rust, or degrade after repeated saltwater exposure.
The biology is simple: shrimp die in buckets because they pile up, deplete oxygen in their zone, and injure each other. The mesh gives them a climbing surface, spreading them vertically. Less crowding = less stress = better water quality = longer survival.
Rinse with fresh water and let it air dry. Soap and water works fine for a deeper clean. It dries flat and stores compact.
It’s optimized for live shrimp — that’s the problem it was designed to solve. Other live bait like freshwater prawns or crawfish may also benefit from reduced crowding and climbing surface.
Questions about the product, bulk orders, wholesale inquiries, or just want to talk fishing — Kenneth answers every message himself.
